How To Add Swap Space on CentOS 7

How to add swap space on CentOS 7, which is a type of virtual memory that can be used to extend the amount of physical RAM available to the system. This can be useful if you are running out of RAM and your system is starting to slow down. This step-by-step guide covers the basics of adding swap space, including creating a swap file and enabling it.

Swap is a space on a disk that is used when the amount of physical RAM memory is full. When a Linux system runs out of RAM, inactive pages are moved from the RAM to the swap space.

Swap space can appear as either a committed swap partition or a swap file. Most of the time when running CentOS on a virtual machine a swap partition is absent so the only option is to make a swap file.

Below are the steps to enable SWAP file on CentOS 7.

Check if your CentOS installation already has swap enabled :

# swapon –show

The Output would be as below:

NAME TYPE SIZE USED PRIO
/dev/sda3 partition 4G 0B -1

If the output is null, it means that the server does not have swap space enabled.

In order to create SWAP file, the user you are logged in with should have sudo privileges or root access to the server.

Follow the steps below to add swap space on a CentOS 7 system.

Create a file which will be used as swap space:

# fallocate -l 8G /swapfile

You can replace the value 8G if you wish to add more swap space on server.

# chmod 600 /swapfile

Set up a Linux swap area on the file:

# mkswap /swapfile

To activate SWAP :

# swapon /swapfile

To make the change permanent, edit the /etc/fstab file:

# vi /etc/fstab

/swapfile swap swap defaults 0 0

Verify the swap is activated on server

# swapon –show

NAME TYPE SIZE USED PRIO
/swapfile file ‭8,192‬M 1055.8M -1

# free -h

     total        used        free      shared  buff/cache   available 
Mem:  4096M       547M       3549M      2.3M        541M        874M 
Swap: 8.0G        1055M        6845M

Adjust Swappiness value

Swappiness is a Linux kernel property that defines how often the system will use the swap space. Swappiness can have a value between 0 and 100. A low value will make the kernel to try to avoid swapping whenever possible while a higher value will make the kernel to use the swap space more aggressively.

# cat /proc/sys/vm/swappiness

30

Set lower value on Production servers

# sysctl vm.swappiness=10

Also make the changes persistent after reboot:

# vi /etc/sysctl.conf

vm.swappiness=10

# sysctl -p